About X-431 Station
DiagnosticsToolbox & AppsFAQ
Initial Use
17
www.x431.com +86 755 8455 7891
LAUNCH
Station
User's Guide
2 Initial Use
2.1 Assembling the X-431 Station
2.1.1 Installing the monitor
1. After the mobile diagnostic workbench is unpacked, step down the left and right parking safety
mechanism on the rolling casters respectively to release them so that the casters can move freely.
(Locked) (Released)
2. After parking, use the foot to step on the parking safety mechanism to lock it. At this time, the workbench
casters are locked and cannot move freely.
3. Install the monitor hook rack in the position indicated as below.
Hook rack
for monitor
Mounting position for monitor hook rack
4. Align the mounting holes on the back of the monitor with the mounting holes on the mount bracket, and
secure them with screws.
Mounting holes on the monitor Mount bracket
5. Locate the three cables (USB cable, HDMI cable, and DC power cord) that are pre-installed in the lifting
drag chain and plug them into the corresponding ports on the monitor body.
To Next Page
Loading...
