Manual Leapfrog Creatr
18 Leapfrog BV
1.4 Connect
In this step we will show you how to connect the printer to your computer.
Phyiscally connect the printer to your computer by inserting the usb cable that is connected to
your printer in the back of the printer.
Open Repetier-Host Leapfrog and go to Printer Settings”.
In the Device manager you can see which COM port you need to select [the number is displayed
after the driver installation] and verify that the baud rate is set to 115200.
By clicking the connect button as indicated in the next screenshot you can connect the printer. It
will turn green when you have clicked it to connect the printer. It take a few seconds for the
printer to connect.
To Next Page
Loading...
Need help?
General