Manual Leapfrog Creatr
83 Leapfrog BV
4.9 Calibrating the heated printbed
To calibrate your heated bed bring your bed to the Z-home postion and make sure that your
nozzles are at the same height. If they are not, please check paragraph 3.6 to level the extruders.
To make sure that your heated printbed is correctly calibrated again you need to send the nozzles
to the four corners of your heated printbed using the X-/+ and Y-/+ buttons.
In each corner you need to see the same distance between the nozzles and the heated bed. You
can adjust this by (un)screwing the bolts that hold the bed in the corner a little as shown in the
picture below. Once the distance is the same at every corner check the z-offset as explained in
par. 3.2 and you are ready to print.
To Next Page
Loading...
Need help?
General