Manual Leapfrog Creatr
44 Leapfrog BV
3.1 Software set-up
.
After you receive you have purchased the software you will receive a product key and a
download link which is http://www.simplify3d.com/downloads/ at the e-mail address you
ordered the software with. The software is distributed via an electronic download.
If you follow the link you will have to enter the product key and select the operating system that
your comput-button to start downloading the
software. Please not that you can download the software for only one computer using one
product key.
.
Now that you have downloaded the installer you can run it to install the actual software on your
computer. At the end of the installation wizard you will be asked to open the Quick start guide.
We recommend you to open and read this file as it provides a great insight in all the features of
the software. You can save the file or access it later from the software via Help Quick Start
Guide.
Before you can start using the software you will to activate it. This can be done via Help
Activate Product. A window will pop up where you will have to enter the product key in order to
activate the Simplify3D software and start printing.
To Next Page
Loading...
Need help?
General