Table of content
1. Installation
1.1 Unpack Page 7
1.2 230 V 115 V Page 9
1.3 Software Page 10
1.4 Connect Page 18
2. Printing
2.1 Print sticker and Kapton tape Page 21
2.2 Connection Page 24
2.3 Preheat Page 25
2.4 Filament Page 28
2.5 Print settings Page 31
2.6 Printing with PVA Page 35
2.7 Start your print Page 36
2.8 When your print is finished Page 40
2.9 Dual color printing Page 41
3. Simplify3D Software
3.1 Software set-up Page 44
3.2 Connection Page 45
3.3 Preheat Page 46
3.4 Manually controlling your Creatr Page 48
3.5 Start your print Page 50
3.6 Extruder jams Page 56
To Next Page
Loading...
Need help?
General