Manual Leapfrog Creatr
9 Leapfrog BV
1.2 230 V 115 V
!!! This step is only necessary if your electrical grid provides 115V !!!
WARNING: NEVER PERFORM THIS OPERATION WHEN THE POWER PLUG OR USB CABLE IS PLUGGED INTO
YOUR CREATR!
If you already connected your Creatr to your computer and power grid, unplug your power cord
and USB cable!
Tilt your Creatr so you can access the bottom. Look for the square hole.
In this hole you can see a yellow sticker and under it a red switch.
Use an Allan key or screw driver to carefully move the switch to the left. Your Creatr now
operates on 115 V.
WARNING: NEVER PERFORM THIS OPERATION WHEN THE POWER PLUG OR USB CABLE IS PLUGGED INTO
YOUR CREATR!
To Next Page
Loading...