Manual Leapfrog Creatr
20 Leapfrog BV
Printing
The following steps are general steps you need to follow when making a 3D print with your Creatr. Please
follow each step to make sure you will be able to print a beautiful print.
This section contains the following:
2.1 Print sticker
o How to check the sticker and how to replace it if necessary
2.2 Connection
o How to connect the printer to the computer using the software
2.3 Preheat
o How to preheat your printer so you are able to print
2.4 Filament
o How to insert or change your filament and extrude a test piece
2.5 Print settings
o Which printing settings are there and when to select which one
2.6 Printing with PVA
o How to print with PVA and necessary maintenance
2.7 Start your print
o How to start a print using a G-code or a STL file
2.8 Dual color printing
o How to print a dual color print
To Next Page
Loading...