Manual Leapfrog Creatr
43 Leapfrog BV
Simplify3D Software
If you are using the paid Simplify 3D software instead of the free Repetier-Host Leapfrog version you will
need different instructions than the ones given above. Simplify 3D has its own quick start guide which
explains most of its features. However this chapter is dedicated to explaining the basics of printing with
the Simplify 3D software more thorough. All advanced manuals that Simplify 3D has created can be
found at http://www.simplify3d.com/support/tutorials/ and we will often refer to tutorials that can be
found here.
This section contains the following:
3.1 Software set-up
o How to check install and set up the software for first use
3.2 Connection
o How to connect the printer to the computer using the software
3.3 Preheat
o How to preheat your printer so you are able to print
3.4 Manually controlling your printer
o How to control your printer manually
3.5 Start your print
o Which printing settings are there and when to select which one
3.6 More information and tutorials
o Where to find more detailed information and specific tutorials
To Next Page
Loading...
Need help?
General