Manual Leapfrog Creatr
40 Leapfrog BV
2.8 When your print is finished
When your print is finished you still have to remove it from the bed and maybe want to create a
smoother finish. This section explains what to do once your print is finished.
The first thing to do when the Creatr has finished building your object is let the bed cool down.
This is to avoid deformation of the print while removing it from the bed. When the bed has
cooled down you can carefully remove it from the sticker. If the sticker is not torn you can re-use
it for your next print.
The easiest way to remove the object is by lifting the corners first. Also a tool such as a putty
knife can be of great assistance.
The easiest way to remove the object is by lifting the corners first. Also a tool such as a putty
knife can be of great assistance.
If you want a smoother and shiny finish of your object you can print it in ABS and finish the print
after you have printed it. You can do so by making the surface slightly rougher with sanding
paper and then sweep it with a little bit of acetone.
To Next Page
Loading...
Need help?
General