4 Troubleshooting - Knowledgebase
4.1 Oh, oh, my filament is not feeding through Page 58
4 Page 59
4.3 Extruder stops mid-print Page 62
4.4 Min-/max temp triggered error messages Page 70
4.5 Nozzle seemed clogged Page 73
4.6 My extruders are not the same height Page 77
4.7 Uploading firmware Page 78
4.8 My STL file contains a hole and needs to be fixed Page 82
4.9 Calibrating the heated printbed Page 83
4.10 Extruder offset Page 84
4.11 Z-height does not match model Page 85
4.12 Checking the size of your z-axis pulley Page 86
4.13 Adjusting the z-offset Page 87
4.14 Checking the internal usb cable Page 89
4.15 Removing the slic3r print profiles Page 91
4.16 Need support? Page 92
Appendix A - Troubleshootingtrees
1a I cannot connect my printer Page 95
1b Firmware Page 96
2 Calibration Page 97
3 My printer makes a lot of noise Page 98
4 Temperature errors Page 99
5 Extruder jams Page 100
Page 101
7 Printer loses connection during print Page 102
8 My print bed doe Page 103
9 My print looks bad Page 104
To Next Page
Loading...
Need help?
General