Manual Leapfrog Creatr
33 Leapfrog BV
Each print setting explained
Below, you can see an overview of all the pre-determined print settings. Please read through all of them
to understand the difference between the settings. Print settings can be selected in the Slicer tab. Print
settings need to be selected before slicing your design as they cannot be altered afterwards.
High quality No support
We advise to select this setting when:
o Your print does not need support &
o You want a high quality print
Printing without support will affect the print time positively. If your print does not need support
and you want a high quality print, select this option. This printing setting can be used by the
Creatr Single and Dual extruder.
High quality Breakaway support
We advise to select this setting when:
o Your print needs support &
o You want a high quality print &
o You do not have a Creatr Dual extruder or soluble support material [PLA or PVA]
Here, you will use ABS for both your object as for your support material. The software will take
into account that you will need to breakaway the support material. Depending on your
requirements you will need to perform finishing techniques like sanding etc. This printing setting
can be used by the Creatr Single and Dual extruder.
To Next Page
Loading...
Need help?
General