Manual Leapfrog Creatr
49 Leapfrog BV
The extrude and retract buttons will extrude and retract filament for the selected extruder.
Please note that this can only be done when the extruder is heated.
The home buttons will move the axes to the home position. The home position is the point
where the coordinates for the axes are 0. You can home each axis individually or use the Home
all-button to home all three axes at once. The home physical home position of the printer is
when the extruder carriage is in the front-left corner and the bed in its most upward position.
N.B.: When you connect your printer and want to use the jog controls, the first thing to do should
always be to home all the axes. This is to avoid any possible damage to the printer.
You can adjust the speeds of the jog control operations in the Speed textboxes. Please note
that these speed settings apply only to the jog control movements and not to the print job
movement. The movement speeds of a print job are contained in the g-code.
To Next Page
Loading...
Need help?
General