Manual Leapfrog Creatr
64 Leapfrog BV
The next steps
If all the checks mentioned earlier turn out to be okay, we advise you to follow the next steps
Clean your nozzle with your filament
It is important that the nozzle has no leftover filament inside it that are stuck. Please heat the
nozzle to 220/230 degrees and retract the filament until it is completely out of the extruder. Cut
off the last part from the just retracted filament and make sure your cut is perpendicular.
Heat the nozzle to 240 degrees Celsius, feed and extrude the filament. Hereby, the filament
should push any clogging parts through the hot end. This is a great way to clean your nozzle
without the hassle of removing the nozzle and placing it in a bowl of dissolvent. We would
recommend doing this on a regular basis when you start your prints as it is a fast and a good
regular check.
Printing at higher temperatures
Printing with a nozzle that is too cold can cause clogging. This can occur mid-print, because the
nozzle temperature fluctuates with a few degrees. If this happens, please increase the
temperature of your nozzle.
You can increase the print temperature by going to Repetier-HosSlicer” tab.
Configure to enter the Slic3r settings menu. In the menu go to the
Filament settings tab and select the filament type of which you wish to change the setting as
indicated in the screenshot below
To Next Page
Loading...
Need help?
General