Manual Leapfrog Creatr
74 Leapfrog BV
Insert the filament in the extruder.
Extrude the new strand of filamentExtrude” to 50 mm
and extrude until filament is extruded through the nozzle.
If the previous step was not the solution, you will need to replace the nozzle with a new nozzle. Please
follow the below mentioned steps carefully.
Heat the extruder that is clogged to 230 degrees.
Take your wrench and loosen the nozzle, do not take it off completely.
Be careful, the extruder is very hot ! ! ! Do not touch it with your bare hands ! ! !
To Next Page
Loading...
Need help?
General