LeeBoy 7000 - OPERATION OF ELECTRIC FLIGHT SCREWS

OPERATION OF ELECTRIC
FLIGHT SCREWS
GENERAL
The electric flight screw is an added convenience to the
operator. A gauge is located on both sides of the paver.
These gauges
will provide the operator with quick refer-
ence to the height of the screed. Refer to figure 13 and
follow procedures below.
1. Before paving, center the electric flight screws by
referring to the screed elevation gauge on each side of
the paver. Raise or
lower until cable end is on cO'.
2. While paving. refer to both gauges and make minor
adjustment to the screed by using the electric flight
screws.
ELECTRIC SCREW
IN CENTER POSITION
FIGURE 13
13