Field Option Description
Ascending Lists are ordered in ascending order of sort
type.
Code Record Before
Meas. or
After Meas.
Sets if the codeblock is saved before or after
the measurement. Refer to "9 Coding".
Code Sets if the code will be used for one, or
many, measurements.
Reset after
Rec
The set code is cleared from the measure-
ment screen after Meas or Store is selected.
Permanent The set code remains in the measurement
screen until manually deleted.
Data Output Sets the location for data storage.
Internal
Memory
All data is recorded in the internal memory.
Interface Data which is normally stored in the onboard
data base will be sent to the interface selec-
ted in the Interface Settings screen
This Data Output setting is only required if
an external storage device is connected and
measurements are started at the instrument
with Dist/Store or Meas. This setting is not
required if the instrument is totally controlled
by a datalogger.
GSI-Format Sets the GSI output format.
GSI 8 81..00+12345678
GSI 16 81..00+1234567890123456
GSI-Mask Sets the GSI output mask.
Mask 1 PtID, Hz, V, SD, ppm+mm, hr, hi
Mask 2 PtID, Hz, V, SD, E, N, H, hr
Mask 3 StationID, E, N, H, hi (Station)
StationID, Ori, E, N, H, hi (Station Result)
PtID, E, N, H (Control)
PtID, Hz, V (Set Azimuth)
PtID, Hz, V, SD, ppm+mm, hr, E, N, H (Meas-
urement)
5.4 Screen & Audio Settings
1.
Select Settings from the Main Menu.
2. On the General page, select Screen….
3. Press the button to scroll through the screens of available set-
tings.
Access
50 Settings
To Next Page
