7 Apps
7.1 Common Fields
The following table describes common fields that are found within the firm-
ware apps. These fields are described here once and not repeated in the app
chapters unless the field has a specific meaning within that app.
Field Description
PtID,
Point,
Point 1
Point ID of the point.
hr Height of the reflector.
Remark /
Code
Remark or Code name depending on the coding method.
Three coding methods are available:
•
Remark coding: This text is stored with the correspond-
ing measurement. The code is not related to a codelist,
it is just a simple remark. A codelist on the instrument is
not necessary.
•
Expanded coding with codelist:
Code
The code that was entered is searched for within the
code list and it is possible to see, change and/or add
attributes to the code. To toggle through the codelist,
change to page 4/4 for TS03 or to page Code for TS07.
•
Quick coding:
Q-Code
Enter the shortcut to the code. The code is selected and
the measurement starts.
Hz Horizontal direction to the point.
V Vertical angle to the point.
Horizontal distance to the point.
Slope distance to the point.
Height to the point.
East Easting coordinate of the point.
North Northing coordinate of the point.
Height Height coordinate of the point.
7.2 Station Setup
7.2.1 Starting
Station Setup is an app used when setting up a station, to determine the sta-
tion coordinates and station orientation. A maximum number of 10 known
points can be used to determine the position and orientation.
Description of fields
Description
72 Apps
To Next Page
