Leica TS07 - 7.6.3 Measure Line & Offset

Description of fields
Field
Option Description
Ref. Height Depending on the task chosen this parame-
ter determines the design height.
•
When measuring to a line, it affects the
height difference value.
•
When staking, it affects the delta height
value.
Start Point Heights are computed relative to the height
of the starting point of the line.
End Point Heights are computed relative to the height
of the end point of the line.
Interpolated Heights are computed along the line.
No Height Heights are ignored
Next step
Select Cont and then Meas Pt or Setout to proceed to a subapp.
7.6.3 Measure Line & Offset
The Measure Line & Offset subapp calculates from measurements or coordi-
nates, longitudinal and orthogonal offsets and height differences of the target
point relative to the reference arc.
Example reference arc - measure line & offset
d2+
d1+
P4
P1
P3
P2
P0
TSOX_036
P0 Instrument station
P1 Start point
P2 End point
P3 Measured point
P4 Reference point
d1+ D Offset
d2+ D Line
Press Meas from the Reference Arc - Info screen.
Description
Access
96 Apps