Description of fields
Field Option Description
Use Indicates if and how a target point is used in
the station calculation.
3D Easting, Northing and Height coordinates are
used for the calculation.
2D Easting and Northing coordinates are used
for the calculation.
1D Only the height of the point is used for the
calculation.
Off The point is not used for the calculation.
ΔHz Display only Difference in direction
D Display only Difference in horizontal distance
D Display only Difference in height
The following are important messages or warnings that may appear.
Messages
Description
Selected point has invalid
data! Check data and try
again!
This message occurs if the selected target
point has no Easting or Northing coordinate.
Max. 10 points supported! 10 points have already been measured and
another point is selected. The system sup-
ports a maximum of 10 points.
No position computed due
to bad data!
The measurements may not allow final sta-
tion coordinates (Eastings, Northings) to be
computed.
No height computed due
to bad data!
Either the target height is invalid or insuffi-
cient measurements are available to compute
a final station height.
Face I-II limit exceeded!
Re-measure point in both
This error occurs if a point was measured in
one face and the measurement in the other
face differs by more than the specified accu-
racy limit for the horizontal or vertical angle.
No data measured! Meas-
ure point again!
There is insufficient data measured to be
able to compute a position or height. Either
there are not enough points used or no dis-
tance measured.
Press Set to set the station coordinates and/or orientation and return to the
Apps Menu.
Messages
Next step
Apps 79
To Next Page
