Leisure Unity 2020 - Truma Aquago Water Heater; Switching on the Appliance; Aquago Comfort Plus; Operating Modes

UNITY MOTORHOME WATER AND PLUMBING SYSTEM
119
4
4
4. Press the exterior water heater switch
5
to either
Eco or Comfort ON position (refer to water heater
operating instructions in the Motorhome Information
Kit for detailed instructions).
5.
Ensure the water heater valves
6
are in the position
shown for normal operation.
6
 ᘐ NOTICE
Always refer to the owner’s manual for the water
heater (included in your Motorhome Information
Kit).
TRUMA AQUAGO® WATER
HEATER
SWITCHING ON THE APPLIANCE
1. Open the access door.
2.
To switch on the appliance, switch the POWER
switch to one of the two “ON” positions. Both ON
positions on the POWER switch have the same
function. Choose your preferred position.
•
When the green power ON LED (1) is lit, the
appliance is switched on.
•
If the red error code LED (2) is lit or flashes,
there is a fault or warning.
AQUAGO® COMFORT PLUS
The appliance is now ready for using the control panel
inside your vehicle.
OPERATING MODES
AquaGo® comfort plus features a control panel to select
the operating mode.
WINTERIZING
Refer to the water heater operating instructions located
in the Motorhome Information Kit for detailed winterizing
procedures.