APPLIANCE AND EQUIPMENT OPERATION UNITY MOTORHOME
82
U24RL REAR LOUNGE
LOWERING THE MURPHY BED
1.
Remove the back rest cushions
7
from the Rear
Lounge and set aside.
7777
2.
Raise the bed support
8
up until it clicks in to place.
8
9
3.
Pull the lock release strap
9
up to release the bed.
4.
Slowly and carefully lower the Murphy bed. Ensure
the Murphy bed locks into place once fully lowered
by lifting slightly on the side of the bed. If bed is
not locked, sit on corner of bed to apply additional
downward pressure.
RAISING THE MURPHY BED
1. Before raising the Murphy bed, be sure to unplug
and remove any devices that may be in the rear
cubby.
ᘐ WARNING
Failure to unplug devices could potentially result
result in a fire if the device overheats.
2. Pull the lock release strap
10
, and slowly raise the
Murphy bed
10
ᘐ CAUTION
Failure to pull the release strap will cause damage
to the Murphy Bed.
3. Once raised, ensure the Murphy bed is secured by
pulling slightly on the top edge. If bed is not locked
in to place, push firmly along the top edge and test
again.
4.
Lower the bed support by lifting slightly, and pushing
upwards in the center of the support
11
, and gently
lowering the bed support.
11
To Next Page
Loading...
