Leisure Unity 2020 - Beds and Seating; Leisure Lounge Plus System (Optional)

APPLIANCE AND EQUIPMENT OPERATION UNITY MOTORHOME
76
BEDS AND SEATING
LEISURE LOUNGE PLUS SYSTEM
OPTIONAL
LOWERING THE MURPHY BED
1.
Refer to the “Slide Out Room” section in the
“Motorhome Operation” section for details.
2. Raise the table
1
, secure in upright position with
latch
3
and fold support/small table
2
.
1
2
3
3. Ensure lounge chairs are in the fully upright position
using recliner buttons
4
on the side of the chair.
4 5
4. Rotate the lounge chairs so they are facing away
from bed by lifting and holding the lock button
5
while you swivel the seat. Release the lock button
when the chair is slightly rotated to ensure the seat
locks into the next position.
5. Remove the lounge chair seat back cushions and
headrests and fold the seat backs forward until
they lay flat
6
.
66
6. Release the locks on both sides of the Murphybed
(rotate to unlock).
7.
Slowly and carefully lower the Murphy bed. Ensure
the Murphy bed locks into place once fully lowered
by lifting slightly on the side of the bed. If bed is
not locked, sit on corner of bed to apply additional
downward pressure.
8.
Lower step cover
7
. Refer to the “Step Cover”
section in the “Motorhome Operation” section for
details.
7
 ᘐ CAUTION
Lower the step cover when lounge chairs
are in recliner mode
7
to prevent tripping
accidents. Refer to the “Step Cover” section in the
“Motorhome Operation” section of this manual
for detailed instructions.