Leisure Unity 2020 - Stabilizers; Leveling Jacks; AUTO-LEVEL Operation

UNITY MOTORHOME MOTORHOME OPERATION
43
 ᘐ CAUTION
Exercise care and caution when parking and
leveling your motorhome. Make sure all pets
and people, especially children, are clear of the
motorhome until leveling is complete and the
motorhome is stable.
STABILIZERS
Your motorhome may be equipped with electric
stabilizers. The stabilizer control panel
4
is located in
the cabinet above the coach entrance doorway. Refer
to the detailed operating instructions in the Motorhome
Information Kit before operating.
NOTE: Refer to the stabilizer system manual in the
Motorhome Information Kit for details on manual
operation of the stabilizers.
4
 ᘐ NOTICE
Always verify that stabilizers are completely
retracted before moving the motorhome.
 ᘐ CAUTION
Use stabilizers to stabilize the motorhome only.
Do NOT use stabilizers to level the motorhome.
LEVELING JACKS
Your motorhome may be equipped with automatic
leveling jacks. The leveling jack control panel
5
is
located in the cabinet above the coach entrance
doorway. Refer to the detailed operating instructions
in the Motorhome Information Kit before operating.
5
6
9
8
7
10
AUTOLEVEL OPERATION
1. Power On: Make sure your parking brake is engaged
and the ignition key is in the OFF position. Press and
release the POWER button
6
to engage power. All
LED’s on the panel will come on then most will go
out. The LED
10
next to the POWER button should be
lit RED when power is on. If you attempt Auto-Level
or manual extend you will hear a “deny” tone if the
key or park brake is in the improper position.
2.
AUTOLEVEL: Press the AUTOLEVEL button
11
and release. The system will send out a continuous
series of beeps, the ‘OPERATING’ LED
9
will be on
RED to let you know AUTOLEVEL is operating and
will automatically level the coach. When completed,
the keypad will signal a successful level with a
dual-level tone. Press and release the POWER
button
6
.
NOTE: The keypad may be left on once level has been
achieved. The keypad will enter “sleep mode” after five
minutes of inactivity.