UNITY MOTORHOME MOTORHOME MAINTENANCE
137
ENTRY DOOR STEP
Periodically lubricate the electric entry door step
mechanism
8
. Refer to the electric step manual in the
Motorhome Information Kit for details.
8
4 POINT LEVELING SYSTEM
Periodically check the transmission fluid in the pump
reservoir
9
and refill as necessary. Refer to the 4 point
leveling system manual in the Motorhome Information
Kit for details.
9
MANUAL OVERRIDE PROCEDURES
If electrical power is lost to the leveling or slide-out
system, your system has been equipped with a manual
override option.
10101010
11
To retract your jacks:
1.
The individual cartridge valves
10
are clustered
together on the side of the pump manifold. Valves
for leveling jacks are labeled 1 through 4. Locate the
screws on the appropriate cartridge valve(s). Using
a 1/8” Allen wrench, turn the screw(s) clockwise
until all the way in and lightly seated. An individual
leveling jack can be manually overridden by only
opening the valve associated with that function.
2. Remove the foil sticker from the end of the motor.
Place the drill with the 1/4 inch Allen driver bit on
the manual override shaft
11
located at the end of
the motor. Run drill in a counter-clockwise direction
at 2000 r.p.m. (minimum). The jack leg(s) will retract.
3. When retraction is complete, return the cartridge
valve(s) to the normal positions.
To extend your jacks: Follow all of the above steps
except run the drill in a clockwise direction
To Next Page
Loading...
