• Use of compressed air that does not meet the quality standards set by
Lely Industries.
• Hacking activities, viruses or the like.
•
Damage to the electrical system as a result of vermin or the like.
• For USERS that have followed the Operators Maintenance and Service
Certification: any damage resulting from abnormal use of the equipment
which is not according to the specifications stated in the Operator
Technical Training Manual and are also not covered by the warranty
scheme.
Before start up of the installation the handover declaration (together with the
LAM form) has to be signed off by the customer and technician. By means of
the handover declaration the installation will be registered at Lely. Warranty
does apply only for correct registered machines.
Warranty does not apply to consequential damage which does not involve
the machine itself.
All systems are tested. However in the event of a malfunction Lely cannot be
held responsible for consequential damage.
1.4 List of Included Amendments
01/03/2016
• Initial release
1.5
Applicability
The table below shows the type numbers of CRS M3 for which this manual is
applicable.
Model designation
Model Type number
CRS M3 5.1004.6866.0
1.6 Registration
The type and serial number plate is attached to:
• The horizontal frame of the robot unit next to the robot control room
•
The vertical frame behind the door of the central unit, next to the air
supply unit
Always include the type and serial numbers of your milking robot when you
contact your local Lely service provider or order spare parts.
Introduction 1-3
PDF of the English original HTML, 5.1004.8514.0 -
To Next Page
Loading...