Text Explanation Action
'Cluster operation':
'Going in operation'
Not all robot units that are connected to
the CRS M3 are fully in operation: a
robot unit can be out of operation locally
(on the RU) and/or remotely (on the
CRS M3).
1. Make sure that all robot units
connected to the CRS M3 are in
operation locally and remotely.
'Cluster operation':
'Out of operation'
The cluster is out or operation.
1. Put the cluster in operation (page 5‑9).
2. Make sure that all robot units
connected to the CRS M3 are in
operation locally and remotely.
'Cluster operation':
'Out of operation'
AND
'Status':
'Cluster cleaning
required'
The cluster is out of operation due to an
error that occurred during a cluster
cleaning.
3.
Put all robot units connected to the
CRS M3 in operation.
4. Put the cluster in operation (page 5‑9).
5. Accept the request to do a cluster
rinse.
6. If an alarm occurs, reset the cluster:
1. In the field 'Cluster operation':
push the button [Reset] > push the
button [On].
2. Make sure that the cluster rinse
has been done.
3. If not, do a cluster
rinse (page 5‑1).
'Status':
'Cluster cleaning
required'
1. Do a cluster rinse (page 5‑1).
6.3 T4C Computer fails
If the T4C computer fails, the CRS M3 and Modalarm web interfaces can
also be opened directly in a web browser on a device with a (wireless)
internet connection.
Please contact your local Lely service provider for information.
6.4 Modalarm Errors
The purple status bar that is visible at the top of each tab shows the alarms
generated by the Modalarm:
Troubleshooting 6-3
PDF of the English original HTML, 5.1004.8514.0 -
To Next Page
Loading...