LELY CRS M3 - Maintenance Authorization

Figure 1. Type and serial number plate
1.7 Maintenance Authorization
Only technicians certified by Lely Industries are authorized to do
preventive and/or corrective maintenance on the CRS M3, except for
the maintenance done by the operator as indicated in the Operator
Manual.
If people, who are not certified by Lely Industries, do maintenance on
the CRS M3, the warranty on the CRS M3 becomes invalid.
At the end of each visit, all work done on the CRS M3 must be written in the
logbook and the logbook must be signed by the certified technician. The
logbook must always be kept near the CRS M3 for the entire life of the
product. The information in the logbook must include:
• The maintenance done (includes also the parts exchanged)
•
The date of the maintenance
• The name of the technician
• The certification level and ID of the technician
Technician Training
All the technicians certified by Lely Industries have completed an approved
training program, and passed written and practical examinations during and
at the end of the training program. The training is given by a product
specialist. The examinations are done under supervision of a master product
specialist and include troubleshooting and corrective maintenance of the
CRS M3.
There are four certification levels:
• Installation Technician (certification valid for two years)
• Service Engineer (certification valid for two years)
• Senior Service Engineer (certification valid for two years)
• Product Specialist (certification valid for one year)
During training, a trainee is permitted to work for up to a maximum of six
months under close supervision of a certified technician. A trainee can only
do work on the CRS M3 in the presence of a certified technician.
1-4 Introduction
PDF of the English original HTML, 5.1004.8514.0 -