LELY CRS M3 - Start the Partial Milk Collection Procedure

Figure 16. CRS M3 control panel
KEY:
1. Milk tank selection button - 2. Tank driver procedure button - 3. Partial milk collection
button - 4. Main tank valve button - 5. Cluster selection button - 6. Twin filter reset button -
7. Alarm buzzer mute button - 8. CRS M3 status LED
3. When the main tank is empty, start the cleaning of the main tank (if
not done automatically).
4. Close the tank valve by hand (or push the button (4) on the CRS M3).
5.
On the main tank stop the tank driver procedure.
The CRS M3 web interface shows the status of the tank driver procedure:
request received, busy, finished or off.
5.1.3 Start the Partial Milk Collection Procedure
5.1.3.1 On the CRS M3
Do not use this procedure to completely empty the main tank.
The main tank must be emptied completely as soon as possible after a
partial milk collection to prevent bacteria related problems.
• The milk jar is used as buffer.
• The main tank is not cleaned after the partial milk collection.
• After a partial milk collection, the milk volume in the main tank counted by
the CRS M3 ('Yield') does not equal the actual volume in the main tank.
1.
Select the applicable main tank with the button (1).
Operating Instructions 5-5
PDF of the English original HTML, 5.1004.8514.0 -