LELY CRS M3 - Operating Instructions for CRS M3; CRS M3 Cabinet Operations

To Next Page

To Previous Page

5. OPERATING INSTRUCTIONS

This chapter contains the instructions to operate the CRS M3.

5.1 CRS M3 Cabinet

5.1.1 Replace a used Filter Element of the Twin filter

A used filter element must be replaced in between two scheduled cluster

cleanings.

The CRS M3 generates an alarm 30 minutes before the next scheduled

cluster cleaning. If the filter is not replaced before the next scheduled cluster

cleaning and there is no clean filter, then the CRS M3 does not switch to the

other filter during the main cleaning.

1. On the CRS M3 cabinet select a cluster with the button (5).

Figure 13. CRS M3 control panel

KEY:

1. Milk tank selection button - 2. Tank driver procedure button - 3. Partial milk collection

button - 4. Main tank valve button - 5. Cluster selection button - 6. Twin filter reset button -

7. Alarm buzzer mute button - 8. CRS M3 status LED

2. Examine the LEDs of the twin filter (6): the red LED(s) shows the filter

element(s) that must be replaced.

Replace the filter element of the applicable filter:

Hold the cap (2) of the filter and remove the tri-clamp (1).

Operating Instructions 5-1

PDF of the English original HTML, 5.1004.8514.0 -