Figure 90. Removing the power supply
Press and hold on the orange release tab.
Grasp the handle and slide the power supply unit out from the server.
After this task is completed
1. Fill the power supply bay with a replacement unit or a filler (see
“Install a hot-swap power supply unit” on
page 202
).
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube
Install a hot-swap power supply unit
Follow instructions in this section to install a hot-swap power supply unit.
About this task
S002
202
ThinkSystem SR860 V2 Maintenance Manual
To Next Page
Loading...
