Figure 112. Removing the processor and memory expansion tray
After this task is completed
• Install a replacement unit (see “Install the processor and memory expansion tray” on page 223) or the
system board air baffle (see
“Install the system board air baffle” on page 227).
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
• If you plan to recycle the system board, follow the instructions in
“Disassemble the processor and memory
expansion tray for recycle” on page 221
for compliance with local regulations.
Demo video
Watch the procedure on YouTube
Disassemble the processor and memory expansion tray for recycle
Follow the instructions in this section to disassemble the processor and memory expansion tray before
recycle.
About this task
Attention:
• Go over
“Installation Guidelines” on page 137 to ensure that you work safely.
• Turn off the server and peripheral devices and disconnect the power cords and all external cables (see
“Power off the server” on page 12).
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top cover,
or remove the server from the rack.
Procedure
Chapter 4. Hardware replacement procedures 221
To Next Page
Loading...
