Lenze 8400 BaseLine C - Page 16

2 Introduction: Parameterising the controller
2.2 Handling the memory module
16
Lenze · 8400 BaseLine C · Reference manual · DMS 1.6 EN · 01/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Parameter set transfer using the »Engineer«
When an online connection to the controller has been established, the following transfer functions
can directly be executed via the Toolbar or the Online menu using the L-force »Engineer«:
 Tip!
Detailed information on parameter set transfers using the »Engineer« can be found in the
»Engineer« online help.
Symbol Menu command Shortcut
Download parameter set <F5>
Read parameter set from device <F7>
Save parameter set