Lenze i510 Series

11.3.3.1 Establishing a direct WLAN connecon between smartphone and inverter
How to establish a direct WLAN connecon to the inverter on the smartphone:
Requirements:
•
The funconal test described in the mounng and switch-on instrucons has been com-
pleted successfully (without any errors or faults).
•
The inverter is ready for operaon (supplied with voltage).
Required accessories:
•
WLAN module
•
Android smartphone
•
Lenze Smart Keypad App (available free of charge in the Google Play Store)
1.Plug the WLAN module onto the front of the inverter (interface X16).
2.Unless already acvated, acvate the WLAN funcon on the smartphone under "Sengs"
à "WLAN".
The WLAN networks available in your range are now displayed.
3.Select the WLAN network established by the inverter.
4.Enter the password for the WLAN network (default seng "password") and click "Connect".
The connecon to the WLAN network of the inverter is now established.
5.Start the Lenze Smart Keypad App on the Android smartphone.
If a WLAN connecon to the inverter has been established, the Lenze Smart Keypad App
serves to
•
read out diagnoscs parameters of the inverter,
•
change parameter sengs of the inverter and
•
transmit parameter sets.
Addional funcons
Wireless LAN (WLAN)
WLAN access point mode
262