Commissioning
Before switching on
7
244
EDS84ASC552 EN 10.0
Selection of the appropriate commissioning tool
There are two ways to commission the 8400 frequency inverter:
ƒ Commissioning using the keypad (or diagnosis terminal)
– For simple drive tasks such as quick commissioning of the ’Speed closed-loop
control’ standard application
ƒ Commissioning using the »Engineer«
– For rather demanding drive tasks such as ’Table positioning’ of the HighLine
version
– Supported by online help and accompanying software documentation (software
manual)
Tip!
Use the »Engineer« to carry out extensive parameter setting and
configuration. The online help which is available for each device and the
accompanying software documentation will assist you.
The L-force keypad can be used for quick commissioning and checking
individual parameters on the controller.
To Next Page
Loading...
