Safety instructions
Standards and environmental conditions
58
Lenze • BA v200-C v800-.C • 1.1
The product is a class B device. Class B devices may cause interference when used in residential
environments.
Make certain that the specified environmental conditions are maintained at all times. Use in
non-specified environments is prohibited.
Attention
The device may only be switched on after acclimatising to the ambient temperature in order
to avoid condensate accumulation. This also applies if the device is exposed to extreme
temperature fluctuations.
To avoid overheating in operation: The device must not be exposed to direct radiation by
sunlight or any other light source.
If the device is installed in a panel, casing or similar, it must be ensured that no heat
accumulation occurs. The maximum permissible ambient temperature must not be exceeded.
Note
For full compliance with the EMC legislation, all components and cables used for device
connection must also be compliant with these requirements. It is therefore necessary to
employ BUS and LAN cables with shielded connectors and these must be installed as per the
instructions contained in the instruction manual.
Standards
The device corresponds to the test instructions for the CE marking according to the European
test standards EN 55022 and EN 61000-6-2
The device corresponds to the DIN EN 60950 (VDE0805, IEC950) test instructions " Safety of
Information Technology Equipment”
The device corresponds to the DIN EN 60068-2-6 (sinusoidal vibration) test instructions
National restrictions:
This device is a class 2 device that must comply with national restrictions for operation in the
individual EU countries (and other countries that comply with EU Directive 1999/5/EC).
A corresponding EC conformity declaration is available for competent authorities at the
manufacturer and can be viewed upon request.
To Next Page
Loading...
