Interfaces
HDBaseT™ Extender Kit
Lenze • BA v200-C v800-.C • 1.1 85
The device must be supplied with 24V +/-25% (18 to 30 V) (NEC Class 2).
The power supply must be implemented via the 3-pole plug only
(3-pole plug, black).
(The figure shows the socket inside the device).
Pin number Signal name
1 24 V
2 PE
3 0 V
Technical data:
Input voltage: 24V +/-25% (18 to 30 V)
(NEC Class 2)
Max. switch on current: 0,6 A
6.3.4 Installation
Open the service slot and slide the receiver module into the mounting slot provided. When the
receiver module is at its end position, the catches of the two locking tabs on the receiver
module must engage in the retainer clips.
Installation of receiver
To Next Page
Loading...
