Lenze v200-C - Cabling; Status Indicators on Transmitter Module

Interfaces
HDBaseT™ Extender Kit
86
Lenze • BA v200-C v800-.C • 1.1
6.3.5 Cabling
See 7.6 Order of steps during commissioning
6.3.6 Status indicators on transmitter module
The transmitter module has status indicators. The table below lists the various system states.
LED status Representation
off
permanently lit
flashing
Signal Action
HDCP
Graphics link is present
PWR
(blue)
The device is supplied with voltage via POWER and is ready
for operation
FW
(off)
No firmware action
Firmware is loaded and ready for operation
HDBT
HDBaseT™ link present
(slow)
Low Power Mode
(fast)
Ethernet Fallback Mode
(off)
No link