Operating and safety instructions
Warranty / repairs
Lenze • BA v200-C v800-.C • 1.1 63
3.3 Warranty / repairs
During the device warranty period, any repairs must only be performed by the manufacturer or
by service personnel that has been authorised by the manufacturer.
3.4 Intended use
The device is used for the visualisation and control of a wide range of processes on systems and
machines in various application environments.
The device is only to be assembled, installed and operated within the permissible specifications.
Use in non-specified environments is prohibited.
3.5 Improper use
Operation other than or beyond that described for the device shall be deemed improper use.
The device is not allowed to be used to control vehicles or for applications for which further
approvals beyond the manufacturer's declaration are necessary, e.g. applications with
explosion hazard, medical technology, shipping industry.
The device must not be put into operation in the case of transport damage or nonconformity
with the specifications and, if necessary, must be taken out of operation in the case of changing
conditions.
In the case of improper use, Lenze shall not accept responsibility or liability for injury or damage
that is directly or indirectly attributable to the handling of the device.
Should the device have evident signs of damages caused, e.g., by improper operation or storage
conditions or due to improper use or handling, it must be shut down immediately. Ensure that
it is secured against being started up accidentally.
Attention
Hazard caused by damage to components containing soft parts!
If the soft material is subjected to a concentrated load, e.g., by placing it on a grating,
impressions will form after some time; the soft plastic does not return completely to its
original shape.
Avoid subjecting the soft material to loads and make sure that a suitable surface is provided
when setting down the device on its display side.
To Next Page
Loading...
