Setting the distinctive ring using the control panel
Distinctive ring is a service provided by some telephone companies that assigns multiple phone numbers to a single
telephone line. If you subscribe to this service, you can program your printer to have a distinctive ring pattern and
phone number for incoming faxes.
1 From the control panel, press Fax Mode.
2 Press .
3 Press or repeatedly until Fax Setup appears.
4 Press .
5 Press or repeatedly until Ringing and Answering appears.
6 Press .
7 Press or repeatedly until Ring Pattern appears.
8 Press .
9 Press or repeatedly until the ring pattern you want appears.
10 Press to save the setting.
Related topics:
• “Using the control panel” on page 95
Setting up Quick Dial buttons using the control panel
1 From the control panel, press Fax Mode.
2 Enter a fax number.
Notes:
• You can include a calling card number as part of the fax number.
• A fax number can include up to 64 characters. Characters can include numbers, the symbols * and #, or a
three-second pause created by pressing Redial / Pause. The pause appears as a comma on the display.
3 Hold down an empty Quick Dial button for two seconds.
4 To program additional Quick Dial buttons, repeat step 2 through step 3.
Note: You can also program any empty Quick Dial button whenever you are prompted to enter a fax number.
Setting the number of rings before receiving a fax automatically using the
control panel
1 From the control panel, press Fax Mode.
2 Press .
3 Press or repeatedly until Fax Setup appears.
4 Press .
5 Press or repeatedly until Ringing and Answering appears.
6 Press .
Faxing using the control panel
26
To Next Page
Loading...
