Lexmark C510 - Page 146

Network Menu
146
Using printer menus
Network
Buffer
To configure the size of the
network input buffer.
Note: Changing the Network
Buffer menu item automatically
resets the printer.
Auto* Printer automatically calculates the
Network Buffer size
(recommended setting).
3K to
maximum
size allowed
User specifies the Network Buffer
size. The maximum size depends
on the amount of memory in your
printer, the size of the other link
buffers, and whether Resource
Save is set to On or Off. To
maximize the range for the
Network Buffer size, disable or
reduce the size of the parallel,
serial, and USB buffers.
Network <x>
Setup
To configure an internal print
server.
Values for this menu item are supplied by the
specific print server. Select the menu item to see
the available values.
Note: Refer to the documentation on the
drivers CD for more information.
NPA Mode To specify whether the printer
performs the special processing
required for bidirectional
communication, following the
conventions defined in the
Network Printing Alliance (NPA)
Protocol.
Note: Changing this menu item
automatically resets the printer.
Off Printer does not perform NPA
processing.
Auto* Printer examines the data to
determine the format and then
processes it appropriately.
PCL
SmartSwitch
To configure the printer so it
automatically switches to
PCL emulation when a print job
received through the network port
requires it, regardless of the
default printer language.
On* Printer examines data on the
network interface and selects
PCL emulation if the data indicates
that is the required printer
language.
Off Printer does not examine the
incoming data. The printer uses
PostScript emulation to process
the job if PS SmartSwitch is On, or
uses the default printer language
specified in the Setup Menu if PS
SmartSwitch is Off.
Menu Item Purpose Values