Lexmark C510 - Page 185

Understanding printer messages
185
Understanding printer messages
83 Photodev Cart Life
Warning
The photodeveloper cartridge is
nearing the end of its life.
• Press Go to clear the message and
continue printing.
• Replace the photodeveloper
cartridge.
See also: Replacing the
photodeveloper cartridge
83 Photodev Cart
Missing
The photodeveloper cartridge is
either missing or incorrectly
installed.
Correctly install the photodeveloper
cartridge to clear the message and
continue printing.
See also: Replacing the
photodeveloper cartridge
87 Fuser Exhausted The fuser is completely used. Replace the fuser.
See also: Replacing the fuser
87 Fuser Life Warning The fuser is nearing the end of its
life.
• Press Go to clear the message and
continue printing.
• Replace the fuser.
See also: Replacing the fuser
87 Fuser Missing The fuser is either missing or
incorrectly installed.
Correctly install the fuser to clear the
message and continue printing.
See also: Replacing the fuser
88 <color> Toner Empty
Open Front Door
Replace <color>
This message is presented for a few
seconds and then is followed by the
secondary message with
instructions. The printer has
detected that the toner supply in the
specified cartridge is empty.
<color> is Cyan, Magenta, Yellow,
or Black.
Open the front door and replace the
specified toner cartridge immediately.
See also: Replacing the toner
cartridges
88 <color> Toner Low The printer has detected that the
toner supply in the specified
cartridge is low. If you do not have
the specified toner cartridge on
hand, order one now. You can
continue printing until 88 <color>
Toner Empty appears and then,
replace the specified toner
cartridge.
Replace the specified toner cartridge.
Press Go to clear the message and
continue printing. The Supplies
message is displayed until you replace
the specified toner cartridge.
See also: Replacing the toner
cartridges
900–999 Service
<message>
Messages 900–999 relate to printer
problems that may require printer
service.
Turn the printer off and check all cable
connections. Turn the printer back on. If
the service message recurs, call for
service and report the message number
and description of the problem.
See also: Calling for service
Message What this message means What you can do