2-10 Service Manual
7013-XXX
56 Standard USB
Port Disabled
This message may appear when data is sent to the printer across a USB port, but
the port is disabled.
Note: Once the error is displayed the first time, reporting of further errors is
suppressed until the printer is reset or menus are entered.
The following actions can be taken:
•Press
Select ( ) to clear the message.
Any data received on the USB port is discarded.
• Press Menus ( ) to access the Busy/Waiting Menu.
The following functions may be available:
- Turn the printer power off and then back on to reset the printer.
- Reset Active Bin
- Check Supply Levels
Make sure the USB Buffer menu item is not set to Disabled. (Press Menus to
access the Administrative Menus, select Network/Ports, USB Menu, and
USB Buffer.)
58 Too many Flash
Options Installed
1. Turn off and unplug the printer.
2. Remove the excess flash memory.
3. Plug in the printer, and turn it on.
58 Too Many
Trays Attached
1. Turn off and unplug the printer.
2. Remove the additional trays.
3. Plug in the printer, and turn it on.
84 PC Kit Life Warning Replace the PC kit to ensure print quality.
84 Replace PC Kit
88 Cartridge Low This warning is displayed when the cartridge is low. Press Check to continue.
88 Cartridge Early Life
Warning
Scanner ADF cover open The cover to the ADF is open.
• Close the ADF cover. If this doesn’t remedy the problem, See “ADF cover
open service check” on page 2-48”.
Scan job too long The scan job exceeds the maximum number of pages.
• Break the scan job into multiple small jobs.
• Cancel the scan job.
Paper cleared Paper is cleared from ADF
• Cancel job
• Restart job - This can only be performed if job recovery is enabled and the job
can be restarted. A new job with the same parameters is started.
User status and attendance messages (continued)
User primary message Explanation
To Next Page
Loading...
Need help?
General
Weight and Dimensions
