Scanning
Scanning using the control panel
Scanning a document
Make sure the printer is connected to a computer, and both the printer and the computer are on.
1 Load an original document facedown in the Automatic Document Feeder (ADF).
2 From the control panel, press Scan Mode.
3 Press or repeatedly until the destination to which you want to scan appears.
4 Press Start Color or Start Black.
5 If you want to save the scanned image, from the software application, click File Save As.
6 Enter the file name, format, and location where you want the scanned image saved.
7 Click Save.
Understanding the Scan menu
To understand and use the Scan menu:
1 From the control panel, press Scan Mode.
The scan default screen appears.
2 Press or repeatedly until the scan destination you want appears.
3 If you do not want to change a setting, press Start Color or Start Black.
4 If you want to change a setting, press .
5 Press or repeatedly until the menu item you want appears, and then press .
6 Press or repeatedly until the submenu item or the setting you want appears, and then press .
Note: Pressing
selects a setting. An * appears next to the selected setting.
7 To go into additional submenus and settings, repeat pressing or repeatedly until the submenu item or the
setting you want appears, and then press
.
8 If needed, press repeatedly to return to the previous menus and make other setting selections.
9 Press Start Color or Start Black.
Use this To
Quality* Adjust the quality of a scan.
Original Size* Specify the size of the original document.
* Temporary setting. For information on saving temporary and other settings, see the related topic, “Customizing
Settings.”
77
To Next Page
Loading...
