Lexmark X5070 - Saving Settings; Understanding the Settings Menu

Saving settings
In a setting menu, an * appears next to the default setting. To change the setting:
1 From the control panel, press Settings, and then press or repeatedly until the setting you want appears,
and then press
:
• To save most settings. An * appears next to the saved setting.
• To select a temporary setting. An * appears next to the selected setting. See the table below for a list of
temporary settings.
Note: The printer reverts to the default setting after two minutes of inactivity or if the printer is turned off.
Temporary settings
Copy Mode
• Copies
• Resize
• Lighter/Darker
• Quality
• Repeat Image
• N-Up
• Original Size
• Original Type
Scan Mode
• Quality
• Original Size
Fax Mode
• Quality
• Lighter/Darker
2 To change the timeout feature:
a Press Settings.
b Press or repeatedly until Device Setup appears, and then press .
c Press or repeatedly until Clear Settings Timeout appears, and then press .
d Press or repeatedly until Never appears, and then press .
3 To change one or more temporary settings into new default settings:
a Press Settings.
b Press or repeatedly until Defaults appears, and then press .
c Press or repeatedly until Set Defaults appears, and then press .
d Press or repeatedly until Use Current appears, and then press .
Understanding the Settings menu
1 From the control panel, press Settings.
2 Press or repeatedly until the menu item you want appears.
3 Press .
4 Press or repeatedly until the submenu item you want or the setting you want appears.
28