14
MultiSITE MS8000 Series Room Controllers
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG Life’s Good” is a registered trademark of LG Corp.
Other Functions / Setpoint Adjustment for Heating Mode
Local humidity only shows on models with the humidity sensor present and when enabled by configuration property RH Display.
Outdoor temperature display is dependent on receiving a valid networked outdoor temperature value.
Automatic Heating / Cooling Mode
Setpoint Adjustment for Heating Mode
In automatic mode, setpoint showing at the top of the setpoint bar located directly under the blue line represents the actual occupied
cooling setpoint.
During occupied setpoints adjustment, large digits are temporarily used to display the occupied Cooling Setpoint or occupied Heating
Setpoint. The actual setpoint is dependent on the last effective demand (heating or cooling). The setpoint on top of the red line repre-
sents the actual occupied heating setpoint. The differential between the occupied heating and cooling setpoint is defined by the minimum
deadband configuration parameter.
Normal temperature display resumes after setpoints are adjusted and the actual occupied heating and cooling setpoints show in the
setpoint bar.
CUSTOMIZED SCREENS
Other Functions
Figure 5: Other Function Displays.
Figure 6: Setpoint Adjustment for Heating Mode Display.
For MS8350 and MS8650
To Next Page
Loading...
