LG MultiSITE MS8000 Series - MS8650 Service View Screens 1 to 9

73
User Manual
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG Life’s Good” is a registered trademark of LG Corp.
SERVICE VIEW SCREENS
MS8650 Service View Screens
The service view screens show the current status of certain points locally on the Room Controller. These points can also be viewed through
the network. Service view values are Read Only values but allow a service contractor to visualize the status of key functionality to correctly
diagnose operational system issues.
Table 54: MS8650 Service View Screen 1 / 9 Parameter Details.
Conguration Parameters Default Value Signicance and Adjustments
Firmware Rev. (Firmware Revision)
Read Only
Shows Firmware version currently installed on the Room Controller. Upgrading to a newer
Firmware version deletes the previous Firmware version, however it is possible to set the
Controller to an earlier Firmware version with the Uploader Tool.
Room Temp. (Room Temperature)
Read Only
Shows the current room temperature. The user can set one of the following temperature
inputs to act as the source for the room temperature’s present value:
Wired: Sensor across UI20 (RS) and common
Internal: Room Controller’s internal temperature sensor
WL 1 to WL 10: Wireless ZigBee end devices
Display Readings: Wired, Internal, WL1 to WL10
UI20 Temp (Room Temperature Sensor)
Read Only
Shows the temperature of the sensor connected to UI20 (RS) terminal.
Outdoor Temp. (Outdoor Temperature)
Read Only
Shows the outdoor temperature on the main screen.
Supply Temp. (Supply Temperature)
Read Only
Shows supply air temperature as measured by the sensor.
MS8650 Service View Screen 1 / 9
MS8650 Service View Screen 1 / 9
Figure 58: MS8650 Service View Screen 1 / 9.
For MS8650 Only
1/9 Service View
Room temp.
xx.x °F
Firmware rev.
1.X.X-X
xx.x °F
UI20 temp.
xx.x °F
Outdoor temp.
xx.x °F
Supply temp.