LG MultiSITE MS8000 Series - Heating Only Configuration; Setpoint Adjustment for Cooling Mode; System Modes

15
User Manual
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG Life’s Good” is a registered trademark of LG Corp.
Time and Date show only when a
network time synchronisation
command is received.
Setpoint value shows if
main display parameter is
set to Setpoint.
F
On / Off icon is used instead of
system mode icon when sequence of
operation is set to either heating on
or cooling only.
F
Cooling Mode or Cooling Only
Sequence of Operation.
Heating Only Conguration / Setpoint Adjustment for Cooling Mode / System Modes
Setpoint Adjustment for Cooling Mode
In Cooling mode, the setpoint displayed in the bar is the current occupied cooling setpoint. During occupied setpoint adjustment, the large
digits are temporarily used to show occupied cooling setpoint while it is adjusted.
Normal temperature display resumes after setpoint is adjusted and actual occupied cooling setpoint shows in setpoint bar.
CUSTOMIZED SCREENS
Heating Only Configuration
Figure 7: Heating Only Conguration Display.
Figure 8: Setpoint Adjustment for Cooling Mode Display.
For MS8350 and MS8650
System Modes
The following apply in System Modes.
Table 1: System Mode Descriptions.
System Mode Signicance and Adjustments
Off Heating, Cooling and Dehumidification demands are ignored.
Auto
Controller automatically toggles between Heating and Cooling modes to satisfy both Heating and Cooling
demands. Dehumidification is allowed.
Cool Controller only satisfies Cooling demands, Heating demands are ignored. Dehumidification is allowed.
Heat Controller only satisfies Heating demands, Cooling demands are ignored. Dehumidification is allowed.