LG MultiSITE MS8000 Series - Device X

93
User Manual
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG Life’s Good” is a registered trademark of LG Corp.
6/7 Configuration
Language English
Units °C
Low backlight 60 %
Night backlight 5 %
RH display Disable
Device X
Function None
Battery None
Address 0xXXXX
Comm. status Online
Status No motion
Temperature XX °F
Table 67: Device X Parameter Details.
Conguration Parameters Default Value Signicance and Adjustments
Function (ZigBee Device Function)
Default Value: None
Shows status of installed ZigBee device.
None: No status reported to the Room Controller
Window: Window sensor installed
Door: Door sensor installed
Motion: Device set to detect motion
Status: Updates the BACnet status of the sensor. No action is taken by the Room Control-
ler.
Remove: Removes device from Device list
Water: Water Leak sensor installed
Choices: None, Window, Door, Motion, Status, Remove and Water
Comm. Status (Communication Status)
Default Value: Offline
Read Only
Shows if device is communicating with the Room Controller
Not paired: Device not paired
Online: Device paired and online
Offline: Device paired but offline
Invalid: Device was paired and Room Controller detected a communication error (selected
function does not match paired sensor functionality).
Display Readings: Nor paired, Online, Offline and Invalid
Battery (Wireless Device Battery)
Default Value: None
Read Only
Shows current status of battery in wireless device.
Display Readings: None, Normal or Low
Device X
This screen is a subset of the Ecosystems screen and shows data for each paired ZigBee device. The temperature parameter is only visible
for ZigBee devices capable of measuring temperature readings. Up to ten (10) Device screens can show.
Device X pages will only show up once devices have been paired.
WIRELESS SCREENS
Device X
Figure 81: Device X Display.
For MS8350 and MS8650