LG MultiSITE MS8000 Series - Ecosystem Settings

91
User Manual
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG Life’s Good” is a registered trademark of LG Corp.
6/7 Configuration
Language English
Units °C
Low backlight 60 %
Night backlight 5 %
RH display Disable
Ecosystem Settings
Network status Not det.
Permit timeout 0 min
Paired devices 0
Permit join Off
Table 65: Ecosystem Settings Parameter Details.
Conguration Parameters Default Value Signicance and Adjustments
Network Status (ZigBee Network Status)
Default Value: Not det.
Read Only
Shows current status of ZigBee network.
Pwr on: ZigBee module detected but not configured
No NWK: ZigBee configured but no network joined
Joined: ZigBee network joined
Online: Communicating
Display Readings: Pwr on, No NWK, Joined and Online
Permit Join
Default Value: Off
Setting to “On” allows the Room Controller to pair with a ZigBee device. Value must be set
to “On” to pair with initial device and then set to “Off” if user wants to prevent additional Zig-
Bee devices from joining the network. Changing this value to “Off” on the Room Coordinator
prevents any new ZigBee devices from joining the network.
Permit join can be On/Off when the Room Controller is a coordinator, however the param-
eter is read only when the Room Controller is a router. Permit join stays On for 3 hours.
On: Allows Room Controller to pair with wireless ZigBee device.
Off: Prevents Room Controller from pairing with wireless ZigBee device, or prevent any ad-
ditional ZigBee devices from joining network.
Choices: On or Off
Permit Timeout (Permit Join Timeout)
Default Value: 0
Read Only
Allows devices to join the Coordinator Controller for 180 minutes from the moment it is set
to ON. Once the timer elapses, no devices will be able to join the network.
Permit Join parameter must be set to “On” to enable this feature.
Range: 0 or 180 minutes
Paired Devices (Paired ZigBee Devices)
Default Value: 0
Read Only
Shows the number of ZigBee devices currently paired with the Room Controller. A maximum
of ten (10) ZigBee PRO devices can be paired with each Room Controller (total of ten [10]
paired devices per Room Controller).
Display Readings: 0 to 10 devices
Ecosystem Settings
The Ecosystem Settings screens show the network status, the number of paired devices as well as information for each paired device. A
maximum of ten (10) devices can be paired to each Room Controller. Tap forward arrow to obtain information on each paired ZigBee device.
WIRELESS SCREENS
Ecosystem Settings
Figure 79: Ecosystem Settings Display.
For MS8350 and MS8650