LG MultiSITE MS8000 Series - Page 57

57
User Manual
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. “LG Life’s Good” is a registered trademark of LG Corp.
CONFIGURATION SCREENS
MS8650 Conguration 10 / 11
For MS8650 Only
MS8650 Configuration 10 / 11
Figure 42: MS8650 Conguration 10 / 11 Display.
10/11 Configuration
Calib. temp.
0.0 °F
Calib. OS temp.
0.0 °F
Calib. humid.
0.0 %RH
RH sensor
None
Table 40: MS8650 Conguration 10 / 11 Parameter Details.
Conguration Parameters Default Value Signicance and Adjustments
Calib. Temp. (Calibration Room
Temperature Sensor)
Default Value: 0°F
Room temperature sensor calibration. Offset can be added or subtracted to actual dis-
played room temperature.
Range: ±5.0°F (±2.5°C)
Calib. OS Temp. (Calibration Outside
Temperature Sensor)
Default Value: 0°F
Outside air temperature sensor calibration. Offset that can be added or subtracted to the
actual displayed outdoor temperature.
Range: ±5.0°F (±2.5°C)
Calib. Humid. (Calibrate Humidity Sensor)
Default Value: 0.0%RH
Offset that can be added or subtracted to actual displayed humidity.
Range: ±15.0%RH
RH Sensor (Relative Humidity Sensor)
Default Value: Internal
Sets the source of the indoor room humidity. This parameter allows the user to designate
either the Room Controller (only models supporting humidity) or any of the bound wireless
devices that support humidity to act as the source for the room humidity.
Internal: Sets the Room Controller as the source for the room humidity.
WL 1 to WL 10: Sets the selected wireless ZigBee PRO device as the source for the room
humidity. Only one device can be selected.
Choices: None, Internal, WL1 to WL10
Calib. humid. conguration is only for models with humidity sensor.